G3 Ion LT Operating Guide

 Shop: G3 Ion LT

DOWNLOAD Ion LT User Manual

Touring:

• Rotate either way just past 90 degrees until is catches in place
• Open toe unit jaws by pressing down on toe lever
• Bump the front of your boot to the plastic alignment towers and press down to engage the front pins
• Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks 
• Flip two heel risers forward as need for added climbing height

Skiing:

• Rotate heel unit so that rear pins face forward
• Bump the front of your boot to the plastic alignment towers and press down to engage the front pins
• Step down to engage rear pins
• Press down on toe lever with ski pole to exit binding

Adjustment:

• Boot sole adjustment of 22 mm, use posi drive #3 bit in lowest rear screw
• Ensure it is adjusted with zero gap on the pins between the rear of the boot and the heel unit
• Lateral release value is adjustable using posi drive #3 screwdriver in the big round dial center of the heel unit. Align the edge of this with the desired release value inside the release indicator window
• Forward release value is adjustable using posi drive #3 in the top rear of the heel unit. Align the indicator on the top with the desired release value

Binding Specifics:

• Heel unit has rearward travel for flexing skis, no gap between the rear of the boot and heel unit.
• The heel tower is symmetrical and can be turned either way for touring mode
• Snow and ice buildup is easier to clear on the G3 bindings due to higher and more open toe piece
• Small plastic plate the the heel risers hinge on can feel. Keep an eye here or notice when risers flap freely. Not a safety concern.