G3 Zed Operating Guide

Shop: G3 Zed

DOWNLOAD Zed User Manual

Touring:

• Rotate either way just past 90 degrees until stops sideways
• Open toe unit jaws by pressing down on toe lever
• Press or step on the brake pad to lock brakes up if brakes are installed
• Bump center plastic piece on toe unit with the front of the boot and press down.
• Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks 
• Flip two heel risers forward as need for added climbing height

Skiing:

• Rotate heel unit so that rear pins face forward
• Bump center plastic piece on toe unit with the front of the boot and press down.
• Step down to engage rear pins
• Press down on toe lever with ski pole to exit binding

Adjustment:

• Boot sole adjustment of 30 mm, use posi drive #3 bit in lowest rear screw
• Ensure it is adjusted with zero gap on the pins between the rear of the boot and the heel unit
• Lateral and forward release values are adjustable using posi drive #3 screwdriver in the top screw on the rear of the heel unit. Ensure the desired release value inside the indicator window

Binding Specifics:

• Heel unit has rearward travel for flexing skis, no gap between the rear of the boot and heel unit.
• The heel tower is symmetrical and can be turned either way for touring mode
• Snow and ice buildup is easier to clear on the G3 bindings due to higher and more open toe piece
• If brakes are installed, they will be loose and rattle. While it may seem improper this is normal