Shop: G3 Ion
DOWNLOAD Ion User Manual
Touring:
- Rotate either way just past 90 degrees until is catches in place
- Press or step on the brake pad to lock brakes up
- Open toe unit jaws by pressing down on toe lever
- Bump the front of your boot to the plastic alignment towers and press down to engage the front pins
- Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks
- Flip two heel risers forward as need for added climbing height
Skiing:
- Rotate heel unit so that rear pins face forward
- Bump the front of your boot to the plastic alignment towers and press down to engage the front pins
- Step down to engage rear pins
- Press down on toe lever with ski pole to exit binding
Adjustment:
- Boot sole adjustment of 22 mm, use posi drive #3 bit in lowest rear screw
- Ensure it is adjusted with zero gap on the pins between the rear of the boot and the heel unit
- Lateral release value is adjustable using posi drive #3 screwdriver in the big round dial center of the heel unit. Align the edge of this with the desired release value inside the release indicator window
- Forward release value is adjustable using posi drive #3 in the top rear of the heel unit. Align the indicator on the top with the desired release value
Binding Specifics:
- Heel unit has rearward travel for flexing skis, no gap between the rear of the boot and heel unit.
- The heel tower is symmetrical and can be turned either way for touring mode
- Snow and ice buildup is easier to clear on the G3 bindings due to higher and more open toe piece
- Small plastic plate the the heel risers hinge on can feel. Keep an eye here or notice when risers flap freely. Not a safety concern.
