Rotate the heel unit 180 degrees so that rear pins face backward
Open toe unit jaws by pressing down on toe lever
Align boot pin holes with front pins, step down
Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks
Flip two heel risers forward as need for added climbing height
Skiing:
Rotate heel unit 180 degrees so that rear pins face forward
Align boot pin holes with front pins, step down. Toe lever remains in first position
Step down to engage rear pins
Press down on toe lever with ski pole to exit binding
Adjustment:
Boot sole adjustment of 1cm, use Torx 20 bit in lowest rear screw. Lefty tighty for Dynafit
Ensure it is adjusted with a 4mm gap on the pins between the rear of the boot and the heel unit
Lateral release value is adjustable using Torx 20 bit on higher rear screw
Forward release is fixed at roughly either 7 or 9 (Speedfit or Speed version bindings respectively)
Binding specifics:
The Speed and Speedfit have optional brakes which screw on the base of the heel unit
Leash can be girth hitched to leash loop which is mounted under the toe piece
Snow and ice buildup is possible under the toe springs if the bindings are open and skis are on a backpack after touring in wetter snow. Clear this area with ski pole tip and open and closing. Lock then unlock to check if binding is fully clamping the boot.
If heel unit is removed from the track, spin the worm drive into the most open position before putting it back on the track
Your are successfully subscribed for email notifications.