Hagan CORE

Touring:

• Rotate rear pins 180 degrees (pins face rearward)
• Open toe unit jaws by pressing down on toe lever
• Align boot pin holes with front pins, step down
• Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks 
• Flip magnetic risers forward as needed for climbing aides
• Press down on front brake to lock it up for touring

Skiing:

• Rotate rear pins 180 degrees (pins face rearward)
• Open toe unit jaws by pressing down on toe lever
• Align boot pin holes with front pins, step down
• Step down to engage rear pins
• Press down on toe lever with ski pole to exit binding

Adjustment:

• Boot length adjustment is changed with #2 phillips driver on lowest screw in the rear of heel unit
• Ensure 4mm gap between rear of boot and heel unit
• Adjust lateral release with #3 posi drive in the upper screw on the rear of heel unit
• Adjust forward release with #2 phillips screw in top of heel unit under risers

Binding Specifics:

• Snow and ice buildup is possible under the toe springs if the bindings are open and skis are on a backpack after touring in wetter snow. Clear this area with ski pole tip and open and closing. Lock then unlock to check if binding is fully clamping the boot