Fritschi Tecton Operating Guide

Shop: Fritschi Tecton

DOWNLOAD Tecton User Guide

Touring:

• Push the heel unit tower forward so that WALK is displayed vertically 
• Either hold brake pad down while pushing unit forward or press down firmly afterwards to raise brakes
• Open toe unit jaws by pressing down on toe lever, window will display OPEN
• Bump front of boot to plastic alignment stoppers in toe piece and press down on green tab
• Lock the toe by pulling up on the toe lever up until WALK is displayed in the window
• Flip two risers forward from heel unit as needed for climbing aides

Skiing:

• Open the heel unit by pressing down on heel tower like a traditional alpine binding
• Open toe unit jaws by pressing down on toe lever, window will display OPEN
• Bump front of boot to plastic alignment stoppers in toe piece and press down on green tab. Toe lever automatically should go to SKI position
• Step down engage heel unit like a traditional alpine binding
• Press down on toe lever with ski pole to exit binding

Adjustment:

• Adjust for boot sole length/forward pressure using posi drive #3 bit in lowest rear screw. 
• Forward pressure is confirmed when screw is flush with housing
• Lateral release value is adjustable using posi drive #3 bit on screw in the rear of the toe piece
• Forward release is adjusted with posi drive #3 bit in the upper rear screw of the heel unit

Binding specifics:

• Forward pressure screw will not be “out” for too loose of an adjustment. It is prudent to adjust the screw inward until it is too tight, and then out until flush