Rotate either way just past 90 degrees until is catches in place
Open toe unit jaws by pressing down on toe lever
Bump the front of your boot to the plastic alignment towers and press down to engage the front pins
Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks
Flip two heel risers forward as need for added climbing height
Skiing:
Rotate heel unit so that rear pins face forward
Bump the front of your boot to the plastic alignment towers and press down to engage the front pins
Step down to engage rear pins
Press down on toe lever with ski pole to exit binding
Adjustment:
Boot sole adjustment of 22 mm, use posi drive #3 bit in lowest rear screw
Ensure it is adjusted with zero gap on the pins between the rear of the boot and the heel unit
Lateral release value is adjustable using posi drive #3 screwdriver in the big round dial center of the heel unit. Align the edge of this with the desired release value inside the release indicator window
Forward release value is adjustable using posi drive #3 in the top rear of the heel unit. Align the indicator on the top with the desired release value
Binding Specifics:
Heel unit has rearward travel for flexing skis, no gap between the rear of the boot and heel unit.
The heel tower is symmetrical and can be turned either way for touring mode
Snow and ice buildup is easier to clear on the G3 bindings due to higher and more open toe piece
Small plastic plate the the heel risers hinge on can feel. Keep an eye here or notice when risers flap freely. Not a safety concern.
Your are successfully subscribed for email notifications.