Plum Race 150 / 170 Operating Guide

Shop: Plum Race 150 / 170

Touring:

• Close the flap over the rear pins
• Open toe unit jaws by pressing down on toe lever
• Align boot pin holes with front pins, step down
• Rotate 90 degrees for flat touring
• Lock the toe by pulling up on the toe lever all the way up through ratcheting clicks 

Skiing:

• Raise the flap to expose the rear pins
• Open toe unit jaws by pressing down on toe lever
• Align boot pin holes with front pins, step down
• Step down to engage rear pins
• Press down on toe lever with ski pole to exit binding

Adjustment:

• Ensure it is mounted or adjusted on track with a 4mm gap on the pins between the rear of the boot and the heel unit
• Torx 25 bit is used for R170 with adjustment track
• It does not have a release value adjustment

Binding Specifics:

• Titanium U spring on R150 will wear out, inspect and chang as necessary
• Snow and ice buildup is possible under the toe springs if the bindings are open and skis are on a backpack after touring in wetter snow. Clear this area with ski pole tip and open and closing. Lock then unlock to check if binding is fully clamping the boot.
• Leash can be girth hitched to hollow section of the toe lever