Meidjo 2.1 Operating Guide

Shop: Meidjo 2.1 + brakes + alpine heel + crampon interface

Touring:

Raise the spring box until the red axl stub that is situated under the spring box settles onto the touring base plate
Press the spring box onto the ski topsheet
Lock the spring box by raising the touring lock to hook the tail end of the red axl stub
Depress the toe lever to open pin wings
Align boot tech fittings with toe pins using step-in positioners, and apply downward pressure to engage pins
Lock the toe lever by pulling toe lever towards boot until last click is heard and toe lever is in near vertical position
Flip heel riser(s) for additional climbing heights (7 and 13 degrees)
To exit binding, depress toe lever to open pin wings and step out

Skiing:

Raise the spring box until the red axl stub that is situated under the spring box settles onto the touring base plate
Depress the toe lever to open pin wings
Align boot tech fittings with toe pins using step-in positioners, and apply downward pressure to engage pins
To exit binding, depress toe lever to open pin wings and step out

Adjustment:

Spring tension - twist red knobs at rear of springs so the white mark is aligned with numbers 1-5, with 1 being 'soft' spring tension and 5 being 'stiff' spring tension

Lateral release value - using 3mm allen key, place into red cavity on left side of clear spring box at rear of heel capture assembly. Turn allen key to move left side of black plastic piece to align with tick marks 1-4. Setting 1 is beginner (easy) release, setting 4 is expert (hard) release

Adding additional springs - backout the red knobs at rear of springs and remove black springs. Slide the small stainless steel springs inside the black springs, and place the springs back in the spring box and tighten red knob
Adding leash cable - insert leash cable eyelet and girth hitch through circular cutout on side of grey aluminum assembly near toe pin wing

Binding specifics:

Locations